Specifications; Operation - Omega Lift 13120 Operating Instructions & Parts Manual

Model Capacity
13060 3 Ton
13120 6 Ton
13200 10 Ton
Oil Filler Plug/Screw
!
Use of this device may require special skills and knowledge. Read, understand, and follow all printed materials provided
with and on this device before use.
Raising the Ram Plunger
1. Assemble the 3-pc handle, ensure that spring clips align with slots.
2. Use the handle to engage and turn the release valve clockwise until firm resistance is felt to further thread engagement.
3. Pump until load reaches desired height. Immediately secure with appropriately rated mechanical devices.
It is recommended you follow the load with cribbing and blocking where practical.
!
Never allow personnel to work or pass under a load until the load is secured by cribbing, blocking, or other mechanical
means.
Lowering
!
Make certain that all personnel are clear of the load before lowering. Control the rate of descent of the load at all times.
The more you open the release valve, the faster the load descends.
1. Use the manufacturer's provided operating handle to engage and slowly turn the release valve counter-clockwise, but no
more than 1 turn.
!
If the operating handle is damaged, operates abnormally, or will not positively engage the release valve, immediately
discontinue use of the jack until a manufacturer's replacement handle assembly can be acquired.
2. Push ram down and handle sleeve in to reduce exposure to rust and contamination after removing jack from under load.
Base Size
(L x W) Min. / Max Height
8-5/8" x 7-1/2"
11" x 7-1/2"
11-5/8" x 9-1/4"
Head Saddle
(not shown)
Carry Handle
Return Spring
Handle Sleeve
Release Valve
Figure 1 - 13060, 13120 & 13200 Nomenclature

SPECIFICATIONS

Toe Saddle
5/8" ~ 5-3/4"
7/8" ~ 6"
1-1/8" ~ 6-1/4"

OPERATION

3
Head Saddle
Min. / Max. Height
9" ~ 14-1/8"
10-1/2" ~ 15-5/8"
11" ~ 16-1/8"
Toe Saddle
Handle
Hydraulic Lift
5-1/8"
5-1/8"
5-1/8"