Craftsman WEEDWACKER 358.796122 Operator's Manual page 15

contact with vegetation. Donot f orce
trimmer line into work a rea.
Trimming
3 inches (8 cm
above ground
SCALPING - The scalping technique
removes unwanted vegetation down
to the ground. Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low the tip of the line to strike the
ground around trees, posts, monu-
ments, etc. This technique increases
line wear.
Scalping
MOWING - Your trimmer is ideal for
mowing in places conventional lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING - The fanning action of the
rotating line can be used to blow away
loose debris from an area. Keep the line
parallel to and above the area surface
and swing the tool from side to side.
j_ Sweeping
MAINTENANCE SCHEDULE
,_WARNING: Disconnect the spark plug before performing maintenance
except for carburetor adjustments.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Check engine oil level
Inspect and clean unit and decals
Change engine oil
Service air filter
Inspect muffler and spark arresting screen
Replace spark plug
Replace fuel filter
Before After
Every Every
Use Use
8 Hours or
Every Season
50 Hours or
Every Season
Change oil after first 4 hours of use, then every 8 hours or every season, Change oil
every 4 hours when operating the engine under heavy load or in high temperatures,
** Clean more often under dusty conditions or when airborne debris is present. Replace
air cleaner parts if very dirty.
15