Advertisement
INTRODUCTION
This Wet/Dry Vac is intended for either commercial or house-
hold use.
IMPORTANT
NOTE
Please Read Carefully
Static Shocks Are Common--In
dry areas or when the rela
tive humidity of the air is low. To reduce the frequency of static
shocks in your home the best remedy is to add moisture to
the air with a console or installed humidifier.
OWNER'S
MANUAL
CONTENTS
Item
Page
Warranty Information ............................................................ 2
Safety Instructions................................................................
2
Introduction...........................................................................
3
Unpacking and Checking Carton Contents ......................... 3
Assembly ..............................................................................
3
Operation ..............................................................................
5
Maintenance .........................................................................
6
Repair Parts ..........................................................................
7
Unpacking and Checking
uarton Contents
Remove entire contents of carton. Check each item against
the Carton Contents List. Notify your Sears Store immediately
if any parts are damaged or missing.
Carton Contents
List
Key
Description
Qty.
A
Vac Assembly ...............................................................
1
B
Hose Assembly ............................................................. 1
C
Rectangular Nozzle ...................................................... t
D
Caster Foot ..................................................................
4
E
Caster ...........................................................................
4
F
Owners Manual ............................................................
!
G
Filter Cage ....................................................................
1
H
Filter ..............................................................................
1
I
Float ..............................................................................
f
J
Filter Plate .....................................................................
t
K
Filter Nut .......................................................................
1
A
B
float/cage assembly
WARNING:
For your own safety, never connect plug to
power source outlet until all assembly
steps are com-
plete and you have read and understood the safety and
operation instructions, Do not operate vac with any parts
damaged or missing.
1. Remove the top section of the vac from the drum and the
drum itself out of the carton. Place the top section of vac
upside down into the drum or place on a clean smooth
surface.
2. Locate the float. Place the float over the opening in the
center of the lid with the words "This Side Towards Lid"
laying face down over the hole.
WARNING: To avoid personal injury or damage to vac be
sure to keep hands, fingers, or any other foreign objects
out of the center opening when assembling
the float.
3. Line up filter cage tabs to the slots in the center ring of the
lid assembly.
4. Push on the filter cage until the tabs snap into the slots for
a secure fit.
NOTE: If the filter cage needs to be removed, because the
float is placed in the wrong way, use a slotted screwdriver and
press the blade against one of the filter cage tabs. Push in on
the tab and lift the filter cage up. Tilt the filter cage slightly
away from the open slot to release the other two tabs. PuLlthe
filter cage away from the lid. To replace, follow float/cage
assembly instructions.
Filter
Cage
_Tabs
Advertisement
