Throttle Control Cable - Craftsman 917.258694 Owner's Manual

SERVICE AN ADJ ENTS
"POSITIVE .... NEGATIVE"
(+) (-)
TO REPLACE HEADLIGHT BULB
= Raise hood.
, Pull bulb holder out of the hole in the backside of the
grill.
,, Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
* Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
, Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at sides, titt toward
engine and lift off of tractor.
= To replace, reverse above procedure.
/ HEADLIGHT
/ _ WIRE
/ ...... CONNECTOR
.GOD--
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 33
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable, ff adjustment is
necessary', proceed as follows:
,, With engine not running, move throttle control lever to
fast position.
o Check that speed control lever is against stop screw. If
it is not, loosen casing clamp sc;ew arid pull throttle
cable until lever is against screw_ Tighten clamp screw
securely,
IDLE FUEL
ADJUSTING
NEEDLE
THROTTLE
CONTROL
CABLE
STOP
SCREW
CLAMP
SCREW
CHOKE
CONTROL
CABLE
FIG. 33
FIG. 32
25