Assembly; Tools Required For Assembly; Operator's Position; Contents Of Hardware Pack - Craftsman 917.295652 Owner's Manual

Your new tiller has been assembled at the factory with exception of thOse parts left unassembled for shipping purposes, To
ensure safe and proper ooeration of your tiller all parts and hardware you assemble must be hghtened securely, Use the
correct tools as necessary to insure proper tightness,
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are isted.
(I) Utility knife
(i) Wire cuttel
(1) Screwdriver
(1) Tire oressure gauge
(!) Pair of pliers
(1) 9/16" wrench
OPERATOR'S PO%T_ON (See Fig. 1}
When right or left hand is mentioned in this manua! it
means when you are in the operating position (standing
behind titler handles),
LE_
FRONT
OPEF_ATOR'S
POSIT_ON
RIGHT
RG., t
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(I) Flat Washer t3/32 x 1 x tl Ga.
(2) Carriage Bo!ts 3/8-t6 UNC x ! Gr. 5 (2) Center Locknuts 3/8_16 UNC
(1) Cable Clip (1) Handle Lock Lever
(2) Hairpin Clips
(1) Pivot BoJt
3/8o16 UNC Grade 5
Extra Shear Pins
6