Craftsman 917.27686 Operator's Manual page 34

TROUBLESHOOTING CHART:
See appropriate section in rnanual unless directed to Sears service center
PROBLEM CAUSE CORRECTION
!. Remove obstruction_
Mower blades will
not rotate
Poor grass
discharge
Headlight(s) not
working
(if so equipped)
Battery will not
charge
.oss of drive
Engine "backfires"
when turning
engine "OFF"
1. Obstruction in clutch
mechanism.
2. Worn/damaged mower drive
belt.
3. Frozen idler pulley,
4, Frozen blade mandrel.
5, Mower belt off engine pulley,
1. Engine speed too slow.
2o Trave! speed too fast.
3. Wet grass.
4. Mower not level.
5. Low/uneven tire air pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and
trash under mower°
8. Mower drive belt worn.
9. Blades improperly installed_
10. Improper blades used.
1 !. Clogged mower vent
holes from buildup of grass,
leaves, and trash around
mandrels.
1. Light switch is "OFF".
2. Bulb(s) or lamp(s) burned out.
3. Faulty light switch_
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator
(if so equipped).
4. Faulty alternator.
t. Freewheel control in
"disengaged" position.
2. Motion drive belt worn,
damaged, or broken.
3. Air trapped in transmission
during shipment or servicing.
Engine throttle control not set
between half and full speed
(fast) position before stopping
engine.
2. Replace mower drive belt.
3o Replace idler pulley.
4.. Contact a Sears or other
qualified service center.
3. Install belt on engine pulley.
1. Place throttle control in
"FAST' position_
2. Shift to slower speed.
3. Allow grass to dry before
mowing.
4. Level mower.
5. Check tires for proper air
pressure.
6. Replace/sharpen blade.
Tighten blade bolto
7. Clean underside of mower
housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge
down.
10. Replace with blades listed
in this manual.
11. Clean around mandrels to
open vent holes.
1. Turn light switch "ON".
2. Replace bulb(s) or tamp(s).
3. Check/replace light switch.
4. Check wiring and connections.
5. Replace fuse.
1. Replace battery.
2. Check/clean all connections.
3r Replace regulator.
4. Replace alternator.
1.
2.
Place freewheel control in
"engaged" position.
Replace motion drive belt.
Purge transmission.
Move throttle control
between half and full speed
(fast) position before
stopping engine.
34