Tine - Craftsman 917.295450 Owner's Manual

MID-WIDTH TILLING - 24 INCH PATH (See Fig. 17)
, Assemble holes "A" in tine hubs to holes "C" in tine
shaft.
FIG. 17
FINAL CHECK "ON" POSITION
= Withtine control"ON"(held down tohandle) push down
on handte to raise tines off the ground.
• Slowly pull recoil starter handle while observing tines,
Tines should rotate forward,
- If tines do not rotate, inner wire of control cable is too
loose,. Loosen cable clip and pull cable up to remove
slack and retighten clip..
• Recheck in "ON" position and adjust if necessary..
NOTE:, If "ON" position check required adjustment, re-
check OFF position adjustment to insure tines do not
rotate when control is "OFF" (up).
NARROW TILLINGtCULTIVATING - 12-314 INCH PATH
(See Fig, 18)
° Remove outer tines°
o o
/'-'1 t
Oll
II©i © ©
INNER TINES ONLY
FIG. 18
NOTE: When reassembting outer tines, be sure right tine
assembIy (marked "R") and left tine assembly (marked "L")
are mounted to correct side of tine shaft..
TINE OPERATION CHECK (See Fig. '19)
...............i
i& WARNING: Disconnectsparkplugwire
from spark plug to prevent starting
while checking tine operation,
For proper tine operation, forward tine control lever must be
against control body and all stack removed from inner wire
of control cable when control is in the "OFF" (up) position.
If lever and cable are loose, loosen cabte clip at tower end
of cable° Pull up on cable to remove slack, without
extending spring on end of cable, and retighten cable clipo
FINAL CHECK "OFF" POSITION
° With tine control "OFF" (up), push down on handle to
raise tines off the ground.
o Slowly pull recoil starter handle while observing tines_
Tines should not rotate.
• If tines rotate, inner wire of control cable is too tight
which is extending lower spring and engaging tines.
Loosen cable clip and push clown on cable only enough
to relieve spring tension_ Tighten cable clipo
° Recheck in "OFF" position and adjust if necessary..
TINE CONTROL "OFF" POSITION
TINE CONTROL
"ON" POSITION
CABLE CLIP TINE CONTROL CABLE
FIG, 19
15