Craftsman 917.28863 Operator's Manual page 10

A. MowerSide SusaensionArms
Q, DeflectorShield
5. INSTALL ANTI-SWAY BAR IS)
(IF EQUIPPED)
ANTI-SWAY BAR IS)
_ Towards Towards
Transaxle Mower Deck _1_
90° End IntegratedWasherEnd
• From right side of mower, first insert
90 ° end of anti-sway bar IS) into hole in
transaxle bracket IT), located near Ieft
rear tire in front of transaxle.
NOTE: Flashlight may be helpful.
_'t f)
Anti-Sway i_ _x, , _y .................. " ,,
Bar IS) U'! i
Location,,,
I _ \
•
Pivot the integrated washer end of anti-
sway bar IS)towards mower deck bracket
on right side of mower. Insert integrated
washer end of bar into hole inrear mower
bracket (D), Move mower as needed to
insert integrated washer end of bar into
rear mower bracket (D).
• Secure with small washer and small
retainer spring as shown,
D. Right SideRear MowerBracket
S. Anti-SwayBar
T TransaxleBracket
l" .............. r
6, ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS
• Positionfront hole inside suspension arm
(A) over pin on outside of tractor chassis
and secure with large washer and large
retainer spring (B),
• Repeat on opposite side of tractor.
NOTE: Depending on model, bracket (_ may
be differentthan shown but hole for anti-sway
bar will be in same position/location,
7. ATTACH REAR LIFT LINKS (C)
Insert rod end of rear lift link (C) into hole
(U) in tractor lift shaft suspension arm
and pivot link down to mower.
Liftrear corner of mower and position slot
in link assembly over pin on rear mower
bracket (D) andsecure with large washer
and large retainer spring.
• Repeat on opposite side of tractor,
10