FujiFilm FINEPIX A310 Owner's Manual page 32

VIDEO OUT socket Switch off the camera and TV. Plug the Video cable
(provided with the camera) into the "VIDEO OUT"
(video output) socket.
_,'_ W hen you plug the video cable into the VIDE() OUT socket,
the LCD monitor display switches off.
t If there is a power ouget available, connect the AC-3V AC
Power Adapter.
2
To video
input socket
Plug the other end of the cable into the video input
socket on the TV. Then switch the camera and TV
on and play back images as you would normally.
Refer to the instructions provided with your TV for more
information on video input for your TV.
The "Camera Connection" section explains how to connect the camera to your computer using the
included USB cable and describes the functions you can use once the camera and computer are
connected.
Refer to Section 5 the first time you connect the camera to your computer.
You must install all of the software before connecting the
camera to your computer.
CD-ROM
(Software for FinePix SX)
[ DSC (Mass storage device) Mode I
This mode provides a simple way to read images from an xD-Picture Card and store images on to
an xD-Picture Card (=P.63).
[PC CAM (PC Camera) Mode I
This function allows you to conduct videoconferencing sessions between PCs connected to the
Internet.
,;t Videoconferencing ("PictureHello") is not supported on Macintosh computers.
,_tConnection is only possible with a FUJIFILM camera equipped with a "PC Camera" function.
Use only the FUJIFILM 'AC Power Adapter AC-3V" or the "AC Power Adapter AC-3VW" bundled
with the PictureCradle CP-FXA10 (-*P.71).
Use the AC power adapter to avoid losing power at inconvenient times, such as when you are
downloading photographed images to your computer. Using the AC power adapter also allows you
to take pictures and play back images without worrying about depleting the batteries.
See P.73 for notes on using the AC power adapter.
If you are using the optional cradle, you must use the AC power adapter bundled with the cradle. The use of AC power
adapters other than the bundled product will cause faults.
;F Only connect or disconnect the AC power adapter when the camera isswitched off.
Connecting or disconnecting the AC power adapter while the camera is switched on temporarily interruptsthe power
supply to the camera, so that images or movies being shot at the time are not recorded. Failing to switch the camera off
first can also result in damage to the xD-Plcture Card or malfunctions during PC connection.
Check that the camera is switched off. Plug the AC
power adapter connector into the "DC IN 3V"
socket and then plug the AC power adapter into the
power outlet.
_The socket-outlet shall be installed near the equipment and
shall be easily accessible.
;FThe shape of the plug and socket-outlet depends on the
country of use.
®
Sold separately
@@
socket
_Load an xD-Picture Card containing
photographed images into your camera. Plug the
AC power adapter connector into the DC IN 3V
socket on the camera and then plug the adapter
itself into the main power outlet.
@Slide the power switch to the side to turn the
camera on.
(_Set the "USB MODE" setting in the "SET-UP"
menu to "[_" (--P.50).
@Slide the Power switch to the side to turn the
camera off.
It is recommended that you use the AC Power Adapter AC-
3V (sold separately) or the AC Power Adapter AC-3VW
bundled with the cradle (sold separately) for the connection.
Constant power supply will prevent successful data transfer
from trouble caused by power supply.
@ Switch your PC on.
_Use the included USB cable to connect the
camera to your computer.
Switch the camera on.
You can switch between "DSC" and "PC CAM" in the camera's SET-UP screen.
62 63