Advertisement
iCE AND WATER
DISPENSER
FEATURES
The ice and water dispenser convenientUydispenses chHUed water, and ice cubes or crushed ice, depending on the model
To operate the ice dispenser, seUectthe ice option desired using the touchpad, Press a gUassagainst the dispensing paddUe
as far up as possiMe to catch aH ice, To stop dispensing ice, pull gUassaway from dispensing paddUe, Do not remove the
gUassuntil the ice has compUeteUy dispensed, (CompUete instructions for the dispenser operation are attached to the inside
of the freezer door,)
How the Water Dispenser
Works
The water tank, Uocatedbehind the drawers in the refrigerator compartment, automatically fills as water is dispensed, For
proper dispenser operation, the recommended supply water pressure should fall between 20 psi and 100 psi,
Water pressure must not exceed 100 Ibs. Excessive pressure may cause water filter to malfunction.
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water, it may take about
11/2minutes
after activating the dispenser paddle before water begins to fill this first glass, Continue flushing the system
for 3 minutes to rid the tank and plumbing connections of any impurities, The water dispenser has a built in shutoff device
that will stop the water flow after 3 minutes of continuous use, Simply release the dispenser paddle to reset the shutoff
mechanism,
Cbemisa s from sma fu"st oning
e0fte"er ca.damage the maker, t he makerconnested
to soft water, ensure that the softener
is maintained
and working properly.
How the/co
Dispenser
Works
The ice maker and container are located in the top of the freezer compartment, After the
refrigerator is installed properly and has cooled for several hours, the ice maker can begin
making ice within 24 hours, Air in new plumbing lines may cause the ice maker to cycle two
or three times before making a full tray of ice, Ice production is controlled by the ice
maker's On/Off power switch, Press the switch to the "0" position to turn it Off and press it
to the 'T' position to turn it On, With no usage it will take approximately 2 days to fill the ice
container, The ice maker also has a built-in wire signal arm,which automatically stops ice
production when the ice bin is full, This signal arm should not be used to manually stop the
ice maker,
Because of new plumbing connections, the first production of ice cubes may be discolored
or have an odd flavor, These should be discarded until the cubes made are free of discoloration and taste,
iCE DISPENSER
TiPS
o
Ice cubes stored too long may develop an odd flavor, Empty the ice container and ensure that the ice maker's On/Off
power switch is turned On (set to the '1" position), The ice maker will then produce more ice,
*
Occasionally shake the ice container to keep ice separated,
*
Keep the ice maker's On/Off power switch turned Off (set to the "O" position) until the refrigerator is connected to the water
supply or whenever the water supply is turned off.
cannot connect a water supply, turn the On!Off swtch tO the Off ('_01 _)position. Otherwise, the ice maker!s valve
may be noisy when it attempts to operate without water.
if the disport!!rig
paddJe is PUshed for more than 4 minutes, the dispenser
motor may overload
_-_
and stop.The
overload
protector
will reset automatically
after 3 or 4 minutes.
o
If a large quantity of ice is needed at one time, it is best to remove cubes directly from the ice container,
o
The following sounds are normal when the ice maker is operating:
*
Ice dropping into ice container
*
Running water
*
Water valve opening or closing
o
Turn Off the ice maker when cleaning the freezer and during vacations,
*
If the ice maker will be turned off for a long period of time, you should also turn off the water supply valve,
13
Hide quick links:
Advertisement
