Installing Line On Spool - Craftsman WEEDWACKER 358.797121 Operator's Manual

a_ To replace the Line on existing Spool:
L) Follow "Installing Spool w/Line;' steps "a-co" and
remove any Line remaining on the Spool o
2.) Use a 40 foot length of 080" diameter' Sears Laser
Line
3_) Insert 1/16to 1/8 inch ofthe end ofthe Line through
the hole in the inner rim of the Spool. Figure 26.
Allow no more than 1/8 inch of Line to extend beyond
the rim to avoid interference with the tapping action
40 Wrap the Line finr_y and evenly onto Spool in a
clockwise direction as shown by arrow on Spool.
Figure 26
NOTE: _he Line must be wrapped firmly and
evenly for proper line feed
5,) Follow "Installing Spool w/Line" steps "d_h/'
b. If the Line breaks off or backs up in the'l¥immer
Head, follow "Installing Spool w/Line;' steps "a-cY
Pull slack in Line until the Line is tightly wound on
Spool, leaving 4-6 inches of extended Line_ Continue
with steps "d-hY
WRAP LINE ON SPOOL
AS SHOWN BY ARROW.
16