Frigidaire CPLEF398DCJ Use & Care Manual page 30

(Removing & Replacing Warming Drawer)
Left Glide
Remove shield on righ
glide, Pull up on left lever
while pushing down on
right lever,
Push down with finger
Fig. 1
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
To Remove and Replace the Warming Drawer (some models)
To Remove Warming Drawer:
I. _ Turn power OFF before removing theWarming Drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hex-head screw
(See Fig. I ). Use a 114"socket and ratchet to remove the shield.
4. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever.
5. Pull the Warming Drawer away from the range.
To Replace the Warming Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (See Fig. 2).
3. Align the glide on each side of the drawer with the glide slots on the range.
4. Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 2-4. This will minimize possible
damage to the bearing glides.
NOTE: The Warming Drawerwill NOT
operate while in the Se!f,C!ean and
!!Oven Lockout" modes
3O