Fuel Filter - Craftsman WEEDWACKER 358.798490 Operator's Manual

CUSTOMER RESPONSIBaLgT E$
REPLACE FUEL FILTER (Fig. 19 & 20)
,, Run fuel tank dry of fuel before proceeding with this
step.
o Remove fuel cap and allow it to hang to side of motor.
i Using a small pair of needle nose pliers, grasp fuel cap
retainer, holding it in tank opening and pull out
With cap out of tank, use a small section of bent wire
similar to that shown in the illustration to catch fuel line
and slowly pull from tank When fuel filter appears in
opening, grasp with fingers and remove from tank.
= Once fitter is out of tank, hold fuel line close to fuel ill-
leE. Remove fuel filter by twisting and pulling at the
same time..
,, Replace fuel fitter.
. Reverse process for installation
Figure 19
• LINE
FUEL LINE
FUEL
FILTER
FILTh. ER
BARREL NECK
Figure 20
GEAR BOX LUBRICATION (Fig. 21)
• Remove the gear box screw using a wrench
= Fill gear box with lithium base gear grease
o Replace and tighten gear box screw securely.
GEAR BOX / GEAR BOX
WASHER
SCREW
Figure 2!
_16-