Advertisement
Available languages
Available languages
LY
TO ASSEMBLE
AND ATTACH GRASS
CATCHER
(See Figs. 3A thru 4)
o
Insert leg of tubular frame through front opening of
grass catcher and thread frame into sewn hem of bag.
NOTE= Keep bag hem gathered on the straight leg of the
tubular frame.
o
When frame comes out the other end of sewn hem,
immediatelywork the end of frame down inside the bag
as shown in inseL
o
Slide sewn hem evenly around the tubular frame until
.
both ends of frame are exposed out of the front open-
ing.
o
Assemble lower frame to tubular frame as shown., Be
sure handle is outside of bag and frames are fully
seated as shown in inset,.
o
Slip vinyl bindings over frame..
NOTE:
If vinyl bindings are too stiff, hold them in warm
water for a few minutes., If bag gets wet, let it dry' before
using,.
°
Close the flip lid. Flplidmustbeclosedwhileoperating
lawn mower.
°
Lift the rear door on the mower housing and place the
rass catcher frame onto the formed tabs on the rear
our hinge bracket°
°
The grass catcher is secured to the lawn mower
housing when the rear door is lowered onto the grass
catcher frame.
CAUTION: Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt
to operate the lawn mower with the rear
door removed or propped open.
i,iii
i,i,,i,i
TUBULAR FRAME
SEWN
SEWN HEM
FLIP LiD
\
FIG. 30
DOOR
BRACKET
GRASS
CATCHER
FRAME
FORMED
TABS
FIG. 4
FIG. 3A
7
Advertisement
