Craftsman 580.752220 Operator's Manual page 13

14.After e ach starting a ttempt, where e ngine f ails to run,
always point g uninsafe direction, press redbutton and
squeeze spray gun trigger t orelease highpressure.
WARHIHG
The high pressure stream of water that this
equipment produces can cut through skin and its
_ nderlying tissues, leading to serious injury and
_ossibleamputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYS pointspraygun in safedirection,pressred button
and squeeze spraygun trigger,to releasehigh pressure, e very
time youstop engine.
NOTE:Always keep the throttle lever in the "Fast" position
when operating the pressure washer.
How to Stop Your Pressure Washer
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW position, then STOPposition.
3. ALWAYSpoint spray gun in a safe direction, push red
button and squeeze spray gun trigger to releaseretained
high water pressure.
iMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
How to Use Accessory Tray
The unit is equipped with an accessorytray with places to
store your spray gun, nozzle extension and quick connect
PrecisionSpray
TM
nozzles. There is also a detachable hose
wrap at the back of the accessorytray to hold your high
pressure hose.
1. Placenozzleextensionin clip on back of accessorytray.
2. Place spray gun through hole on accessory tray on right
side of unit.
3. Insert multi-colored nozzlesin spaces provided in
accessory tray.
4. Wrap high pressure hose on hose wrap then attach hose
wrap to back of accessory tray.
5. Hook provided on back of accessorytray for safely
storing safety goggles.
How to Use PrecisionSpray
TM
Hozzle System
The quick-connect on the nozzle extension allows you to
switch between five different PrecisionSpray
TM
system
nozzles. PrecisionSpray
TM
nozzlescan be changed while
pressure washer is running once spray gun trigger lock is
engaged.
FolJow these instructions to changePrecisionSpray
TM
flozzJes:
1. Pull back collar on quick-connect and pull current
PrecisionSpray
TM
nozzle off. Store PrecisionSpray
TM
nozzles in holder provided on the accessory tray.
WARHIHG
The high pressure stream of water that this
_ equipment produces can cut through skin and its i under y ng tissues, leading to serious injury and
j possible amputation.
, NEVER exchange nozzles withoutthe triggerlockedon the
spraygun.
, DONOTtwist nozzles whilespraying.
2. Select desired PrecisionSpray
TM
nozzle:
• Select orange general PrecisionSpray
TM
nozzle for all
purpose cleaning. Cleans vinyl siding, brick patios,
concrete driveways and other surfaces.
* Select red max PrecisionSpray
T M
nozzlefor maximum
cleaning. Greatfor cleaning stubborn stains, including
grease,tar, wax, and other hard to remove stains.
Select cyan jet flush PrecisionSpray
TM
nozzle for
quick high flow clean up and long reachcleaning of
second story siding and windows.
JET FLUSH
13