Frigidaire CRA065AT711 Use & Care Manual page 10

Operating Instructions
(continued)
TO TURN UNIT OFF:
remote
sensing
temp/timer
auto J
hi m
reed
lo
V
0N=0FF
A FAN SPEED
__ DO THIS:
1
PRESS
ON/OFF BUTTON
fi[ter
reset
steep
YOU WILL SEE:
temp/timer euto I
sensing
med
to
reset
V ON=OFF A FAN SPEED
steep
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features inyour controlthat you should become familiar with.
/_ • The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. /_
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue
±
to run during this time.
• There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having
to roll through to select another mode.
• The control will maintain the set temperature within 1 degrees Celsius, between 16 °C and 32 °C.
• After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
Figure 1 (VENT CLOSED)
Figure 2 (FRESH AIR)
Fresh Air Vent Control (on some models)
The Fresh Air Vent allows the air conditioner to:
Recirculate inside air - Vent Closed (see Fig. 1)
2. Draw fresh air into the room - Fresh Air (see Fig. 2)
3. Exchange air from the room - Vent Open (see Fig. 3)
AUGER WHEELS
(8-WAY)
Air Directional Louvers
Air directional louvers control air flow direction. Your air conditioner has the louver
type described below.
Auger Type
The louvers will allow you to direct the air flow Up or Down and Left or Right
throughout the room as needed. Rotate the Auger Wheels until the desired
Left/Right direction is obtained. Pivot horizontal louvers until the desired
Up/Down direction is obtained.
@2009 Electrolux Home Products, Inc. All rights reserved.