Download Print this page

Craftsman BRUSHWACKER 358.795810 Operator's Manual page 9

32cc/1.9 cu.in. 2-cycle gasoline brushwacker

Advertisement

Available languages

Available languages

NOTE: Make sure all parts are in place
as illustrated, and the blade is sand-
wiched between the dust cup and the
retaining washer. There should be no
space between the blade and the dust
cup or the retaining washer.
7. Align hole in dust cup with hole in
side of gearbox by rotating the
blade.
8.
Insert a small screwdriver
into
aligned holes. This will keep the
shaft from turning while tightening
the blade nut.
Screwdriver _
9.
Tighten blade nut firmly with a
wrench while holding screwdriver in
position.
10. Remove the screwdriver.
11. Turn blade by hand. If the blade
binds against the shield, or appears
to be uneven, the blade is not cen-
tered, and you must reinstall.
NOTE:
To remove blade, insert screw-
driver into aligned holes. Unthread the
nut and remove parts. Be sure to store
parts and instructions for future use.
KNOW
YOUR
BRUSHWACKER
READ THiS OPERATOR'S
MANUAL AND SAFETY
RULES BEFORE
OPERATING
YOUR
UNIT. Compare
the illustrations
with
your
unit to familiarize
yourself
with
the location
of
the various
controls
and adjustments.
Save
this manual
for future
reference.
T_ih
ield
Shaft
jHandlebar
Line Limiter
Blade
ON/OFF Switch
Starter Handle
Primer Bulb
/
Blade
ON/OFF
SWITCH
The ON/OFF SWITOH is used to stop tile
engine. Move the switch to the OFF
position to stop the engine.
PRIMER BULB
The PRIMER BULB removes
air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
Muffler
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Activate
the starting system by moving the start
lever to the START position. DO NOT
squeeze the throttle trigger until the en-
gine has started and runs. After the en-
gine starts, allow the engine to warm-
up 5 seconds, then fully squeeze the
throttle trigger to deactivate the starting
system (start lever returns to RUN posi-
tion).

Advertisement

loading