Table of Contents
Advertisement
GENERAL
Only theparts shown onparts list,page 13,am
intended to berepaired o r replaced b ythecustomer. All
other
parts represent an importantpart of the double
insulationsystem and shouldbe serviced only at a
Sears Service Center.
Avoid using solventswhen cleaning plasticparts. Most
plasticsare susceptibleto damage from various types
of commemial solventsand may be damaged by their
use. Use clean clothsto remove dirt, carbon dust, etc.
_IL WARNING: Do not at any time let brake fluids,
gasoline, petroleum-basedproducts,penetrating
oils,etc. come in contact with plastic parts.They
containchemicals that can damage, weaken or
destroyplastic.
It has been found that electrictools are subjectto
accelerated wear and possible premature failure when
they am used on fiberglass boats, sports cars,
wallboard, spacklingcompounds, or plaster. The chips
and grindingsfrom these matedals are highlyabrasive
to electrictool parts, such as bearings, brushes,
commutators,arc. Consequently, it is not recommended
that this tool be used for extended work on any
fiberglass material, wallboard, spacklingcompounds,or
plaster. During any use on these materials, it is
extremely importantthat the tool is cleaned frequently
by blowingwith an air jet.
LUBRICATION
All of the bearings in this tool are lub_catedwith a
sufficientamount of high-grade lubricantfor the life of
the unit under normal operating conditions.Therefore,
no further lubricationis required.
_1_ WARNING: Always wear safety goggles or safety
glasses with side shieldsduring power tool opera-
tion or when blowingdust, If operation is dusty,also
wear a dust mask,
DOUBLE INSULATION
Double insulationis a concept in safety in electric
powertools, which eliminates the need for the usual
three-wire groundedpower cord. All exposed metal
parts are isolated from the internal metal motor
components with protecting insulation.Double insulated
tools do not need to be grounded.
IMPORTANT
Servicingof a toolwith double insulationrequires
extreme care and knowledgeof the system and should
be performedonly by a qualified service technician. For
service, we suggestyou retum the tool to your nearest
Seam store for repair, Always use odginelfactory
replacement parts when servicing.
EXTENSION
CORDS
The useof any e0(tension cord will cause some loss of
power, To keap the loss to a minimumand to prevent
tool overheating, use an extension cordthat is heavy
enough to carry the current the tool will drew.
Awire gage size (A,W,G.) of at least 16 is
recommendedfor an extension cord 100 feet or less in
length,When workingoutdoors, use an extension cord
that is suitablefor outdoor use, The coN's jacket will be
marked WA,
• IL CAUTION: Keapextension cordsawayfmmthe
ddllingarea and positionthe cord so that it will not
get caught on lumber,tools, etc., duringdrilling
operation.
_1= WARNING: Check extensioncords before each
use. If damaged replace immediately.Never use
teal with a damaged cord since touchingthe
damaged area could cause electrical shock result-
ing in seriousinjury.
Extensioncordssuitablefor use with your ddll are
available at your nearest Sears Retail Store.
11
Advertisement
Table of Contents
