Craftsman 315.174710 Owner's Manual page 11

MAINTENANCE
DEPTH ADJUSTING RING
ADJUSTMENTS OR REPLACEMENT (Continued)
To replace depth adjusting ring;
3 Remove depth stop rings, To remove: Depress lip on
depth stop ring and sfide end of depth stop ring over Itp_
See Figure 15.
4, Remove screw from rear of depth adjusting ring. See
Figure 16_
5. Remove two screws on front of depth adjusting ring,
Also remove slide nut from pocket inside clamping le-
ver. NOTE = Depth adjusting ring replacement ls the
only time bottom screw should be removed.
6. Remove depth adjusting ring
7. Position new depth adjusting ring in place and secure
with the same screws and slide nut used to secure old
depth adjusting r_ng.
8. Make all adjustments with top screw (#10-32 x 15/16 =
FiL Hd,) as mentioned previously. Bottom screw (#6-
19 x 1/2" Pan Hd,) should have up to a maximum 'U4"
(.250) clearance, allowing flexibility for top screw ad-
justments See Figure 17.
=ill
REAR OF DEPTH ADJUSTING RING
_EW
Fig. 16
FRONT OF DEPTH ADJUSTING RING
1/4" {.250) MAXIMUM CLEARANCE
Fig. 17
Page 11