Craftsman 315.174710 Owner's Manual page 12

MAINTENANCE
GENERAL
Only the parts shown on parts list, page 15, are intended to
be repaired or replaced by the customer All other parts
represent an important part of the double insulation system
and should be serviced only by a qualified Sears service
technician.
Avoid using solvents when eteaning plastic parts. Most
plastics are suscept+ble to various types of commercial
solvents and may be damaged by their use Use clean
cloths to remove dirt, carbon dust, etc
When electric tools are used on fiberglass boats, sports
cars, wallboard, spackling compounds, or plaster, it has
been found that they are subject to accelerated wear and
possible premature failure, as the fiberglass chips and
grindings are highly abrasive to bearings, brushes,
commulator, etc Consequently, it [s not recommended that
this tool be used for extended work on any fiberglass material,
wa!iboard; ° spack+ing compounds, or ptaster. During any
use on fiberglass it is extremely important that the tool is
cleaned frequently by blowing with an air jet
PROPER CARE OF CUTTERS
Get faster more accurate culting results by keeping cutters
clean and sharp. Remove atl accumulated pitch and gum from
cutters after each use
A cutter sharpening kit (Cat No 9-66501) is available from
Sears Catalog Order or Retail Stores
When sharpening cutters, sharpen only the inside of the
ct._tting edge Never grind the outside diameter Be sure when
sharpening the end of a cutter to grind the c+earance angle the
same as originally ground
EXTENSION CORDS
The use o{ any extens+on cord wit{ cause some _oss of power,
To keep the _oss to a minimum and to prevent toot overheat+
ing, follow the recommended cord sizes on the chart at the
right When toot is used outdoors, use only extension cords
suitable tor outdoor use and so marked Extension cords are
available at Sears Catatog Order or Retail Stores
PROPER CAREOFCOLLET
From time to time, it atso becomes necessary to clean your
coflet and coder nut To do so, simply remove col+e! nut from
coltet and clean the dust and chips that have collected Then
return collar nut to its original position
LUBRICATION
All of the bearings in this toot are _ubr[cated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required
Extension Cord Length Wire Size A.W,.G.
0-25 Feet 18
25-50 Feet 16
50-100 Feet 14
y +
Page 12