Table of Contents
Advertisement
,,, ,,,
,,,,,,,,,,,,,,,,,,,,,,,,,,,,
,,,,,,, ,
,
, ...........................
ASSEMBLY
--
ttttttit
t
I
ii
...,
,
......................
HOW TO ASSEMBLE
YOUR
• Insert the debris shield bracket, attached to the tube,
WEEDWACKER
ASSIST
HANDLE ASSEMBLY
(Fig. 1)
CAUTION:
WHEN
ADJUSTING
THE
ASSIST
HANDLE
FOR COMFORT,
BE
SURE
THAT
THE
ASSIST
HANDLE
REMAINS
BETWEEN
THE TRIGGER
HOUSING
AND THE SAFETY
LABEL.
FIGURE 1.
NOTE: For pre-assembled units, simply loosen assist
handle knob and rotate assist handle to the operating
position, being sure to align between safety label and
throttle trigger housing.
• Rotate assist handle from left to right to tilt the angle of
the semi-automatic head when cutting a large, slopes
area such as a ditch bank.
• Tighten assist handle knob securely.
TUBE
ASSIST
KNOB
SQUARE HEAD
SCREW
ASSmT
Figure 1
INSTALUNG
THE DEBRIS SHIELD (Fig. 2)
WARNING:
THE UNE UMITER
IS SHARP AND CAN
CUT YOU. BE SURE TO WEAR GLOVES
WHILE WORKING WITH THE LINE MMITER.
THE DEBRIS SHIELD MUST BE PROPERLY
INSTALLED
FOR
ALL
LINE
TRIMMER
USAGE. THE DEBRIS SHIELD PROVIDES
PARTIAL PROTECTION
FROM THE RISK
OF
THROWN OBJECTS TO THE OPERA-
TOR AND OTHERS.
DO
NOT
ALTER
OR
REMOVE
THE
TAB ON THE SHIELD BRACKET.
WHEN
INSTALLED
CORRECTLY,
THE BRACKET
TAB ENSURES PROPER DEBRIS SHIELD
AUGNMENT.
FAILURE TO INSTALL THE
DEBRIS SHIELD IN POSITION SHOWN IN
ILLUSTRATION CAN RESULT IN SERIOUS
INJURY TO THE OPERATOR.
into the slot in the debris shield.
• Turn debris shield while aligning and inserting debris
shield screw into hole located in debris shield bracket.
- Assemble the debds "shield knob onto the debris shield
screw.Tighten securely.
NOTE: It is possible that a small space will be left
between the debris shield and the debds shield bracket
when the shield screws are fully tightened.
TUBE
DEBRIS SHIELD
SLOT
DEBRIS SHIELD
KNOB
DEBRIS SHIELD
DEBRIS SHIELD
SCREW
(INSTALLED)
BRACKET
SHOULDER
Figure 2
SEMI-AUTOMATIC
HEAD ASSEMBLY
(Fig. 3)
• Place the dust cup over the hex nut on the bottom of the
tube. The hex nut should fit completely inside the dust
cup.
• Hold the dust cup with a wrench to keep the arbor shaft
from turning
• Thread the semi-automatic head onto the arbor shaft
against the dust cup and tighten firmly with your hand.
NOTE: Unless semi-automatic
head is tightened ade-
quately, it can unthread when engine is started or stopped.
If the situation occurs, reinstall the semi-automatic
head
and tighten more securely.
HEX.---"P
NUT J
ARBOR
SHAFT
TUB I
USE A WRENCHTO HOLD THE
DUSTCUP WHILE
SPINNING
THE SEMI-AUTOMATIC HEAD
ONTHE UNIT
,
Figure 3
CHECK
LIST
° Check all fasteners, make sure they are tight and there
are no loose parts.
• Check to make sure the throttle cable is positioned cor-
rectly.
• With the unit held in the operating position, adjust the
assist handle up or down the tube for best comfort and
balance before first use.
-
-7-
Hide quick links:
Advertisement
Table of Contents
