Installing Drawers - Craftsman HEAVY DUTY TOOL CHESTS Operator's Manual

Install (2) 5/16-18 Batt Studs into top tray using (2)
5/16-18 Ctip-on Nut. (Bali Studs should face towards the
middle of the unit.) Tighten using 1!2-in wrench.
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops). Putt out to remove.
5/16 - 18
Clip-on Nut
5/16- 18
Ball Stud
Instatl Gas Spring as shown in image below by pushing
the sockets onto Batt Studs (cylinder side up).
)
/
Tab Style -Depress the release tabs on both sides,
(this allows the slides to ride over the stops.) Putt out to
remove.
Gas
Spring
Close and open cover to check Gas Springs are properly
installed.
Q REMOVING DRAWERS
Empty the drawer.
Fully extend the drawer.
Release
_ iNSTALLiNG DRAWERS
Ba_ bearing slide - Putt slides and slide carrier out to futty
extended position (see illustration.) Hotd the stide on the
cabinet white aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its futty closed position to engage slide. Open
drawer and rectose to ensure proper operation.
Slide carrier
Slide