18.0 hp electric start 42" mower 6 speed transaxle (61 pages)
Summary of Contents for Craftsman 917.272453
Page 1
Call: Read and follow all Safety 1-800-659-5917 Rules and Instructions before operating this equipment. Sears Craftsman Help Line 5 am- 5 pm, Mon - Sat Sears, Roebuck and Co., Hoffman Estates, II 60179 U.S.A. Visit our Craftsman website:www.sears.com/craftsman...
Page 2
Service ....... Back Cover LIMITED WARRANTY ON CRAFTSMAN RIDING EQUIPMENT For two (2) years from the date of purchase, if this Craftsman Riding Equipment maintained, lubricated and tuned up according to the instructions in the owner's manual, Sears will repair or replace...
Page 3
iMPORTANT: This cutting machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. • Be sure the area is clear of other people _l, Look for this symbol to point out before mowing.
Page 4
• Never carry children. They may fall off • Mow up and down slopes, not across. and be seriously injured or interfere • Remove obstacles such as rocks, tree with safe machine operation. limbs, etc. • Never allow children to operate •...
Page 5
• Remove obstacles such as rocks, tree • Be sure the area is clear of other limbs, etc. people before mowing. Stop machine • Watch for holes, ruts, or bumps. anyone enters the area. Uneven terrain could overturn • Never carry passengers or children even with the blades off.
Page 6
PRODUCT SPECIFICATIONS CONGRATULATIONS on your purchase of a new tractor, It has been designed, Gasoline engineered and manufactured to give Unleaded Capacity you the best possible dependability Regular Type: performance. SAE 30 Should you experience any problem you _)il Type cannot easily remedy, please contact a _,PI-SF-SJ): (above 32°F)
Page 7
Steering Wheel Steering Wheel Insert (1) Large Flat Washer (1) Locknut 1/2-20 (1) Hex Bolt 1/4-28 x 1-1/4 (1) Locknut 1/4-28 Steering Extension Adapter Steering Shaft Steering Wheel Boot Seat (1) Washer 17/32 x 1-3/16 x 12 Gauge ___ (1) Knob Drain Tul:_ For Future Use Video Cassette...
Page 8
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
Page 9
(See INSTALL SEAT TO ROLL TRACTOR OFFSKID Adjust seat before tightening adjustment Operation section for location knob. function of controls) 1. Remove adjustment knob and flat 1. Press lift lever plunger and raise washer securing seat to cardboard attachment lift lever to its highest packing and set aside for assembly position.
Page 10
CHECK FOR PROPER POSITION OF INSTALL MULCHER PLATE ALL BELTS (If previously removed) 1. Raise and hold deflector shield in See the figures that are shown for replacing motion and mower blade drive upright position. Place front of mulcher plate over front belts in the Service and Adjustments of mower deck opening and slide into...
Page 12
KNOWYOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. Light Switch Position Attachment Ignition Clutch Lever Ammeter...
Page 13
The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses.
Page 14
Lower mower with attachment lift The cutting height range is approximately control. 1-1/2" to 4". The heights are measured from the ground to the blade tip with the 3. Start mower blades by engaging attachment clutch control. engine not running. These heights are approximate...
Page 15
TOWING CARTS AND OTHER ATTACH- longer. Drain the gas tank, start the MENTS engine and let it run until the fuel lines and carburetor are empty. Usa fresh fuel Tow only the attachments that are next season. See Storage Instructions for recommended by and comply with additional information.
Page 16
COLD WEATHER STARTING (50 ° F and • Do not mow grass when it is wet. Wet below) grass will plug mower and leave 7. When engine starts, slowly push undesirable clumps. Allow grass to dry choke control in until the engine before mowing.
Page 17
FILL IN DATES REGU . SERV,OE " SERVICE OATES Check Brake Operation Check Tire Pressure Check Operator Presence Interlock Systems R CheckforLooseFasteners i If Sharpen/Replace Mower Blades Lubdcafion Chart Check Battery Level Clean Battery and Terminals Check Transaxle Cooling Ik# # Check V-Bstts Check Engine Oil Level Change Engine Oil (with oil...
Page 18
TRACTOR IMPORTANT: To ensure proper assembly, center hole in blade must align with star Always observe safety rules when on mandrel assembly. performing any maintenance. Reassemble blade bolt, lock washer BRAKE OPERATION and flat washer in exact order as If tractor requires more than six (6) feet shown.
Page 19
BATTERY NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in Your tractor has a battery charging system cold weather, these multi-viscosity oils will which is sufficient for normal use. How- result in increased oil consumption when ever, periodic charging of the battery with used above 32°F.
Page 20
Use gauge on oil fill cap/dipstick for CLEAN AIR INTAKE/COOLING AREAS checking level. For accurate reading, To insure proper cooling, make sure the tighten dipstick cap securely onto the grass screen, cooling fins, and other tube before removing dipstick. Keep external surfaces of the engine are kept oil at "FULL"...
Page 21
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING SERVICE OR ADJUSTMENTS: 1. Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in "DISENGAGED" position. 4. Turn ignition key to "STOP" and remove key. Make sure the blades and all moving parts have completely stopped.
Page 22
• To tower front of mower loosen nut "E" TO LEVEL MOWER HOUSING on both front links an equal number of Adjust the mower while tractor is parked turns. on level ground or driveway. Make sure • When distance "D" is 1/8" to 1/2" lower t res are properly inflated (See "PROD-...
Page 23
TO REPLACE MOTION DRIVE BELT Mandrel Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest. BELT REMOVAL 1. Remove mower (See "TO REMOVE MOWER" in this section of manual).
Page 24
TRANSAXLE GEAR SHIFT LEVER Replace washers and snap retaining NEUTRAL ADJUSTMENT ring securely in axle groove. Replace axle cover. The transaxle should be in neutral when NOTE" To seal tire punctures and the gear shift lever is in neutral (N) (lock prevent flat tires due to slow leaks, gate) position.
Page 25
TO REPLACE HEADLIGHT BULB 1. Raise hood. Pull bulb holder out of the hole in the backside of the grill. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. Close hood. INTERLOCKS AND RELAYS Weak or Dead...
Page 26
ENGINE TO ADJUST CARBURETOR Maintenance, repair, or replacement of the Your carburetor is not adjustable. If your systems, emission control devices and w h_.h engine does not operate properly due to are being done at the customers expense, suspected carburetor problems, take your tractor to an authorized service center for may be performed by any non-road engine repair establishment or individual.
Page 27
Immediately prepare your tractor for storage at the end of the season or if the alcohol blended fuels (called gasohol using ethanol or methanol) can attract tractor will not be used for 30 days or more. moisture which leads to separation formation of acids dudng storage.
Page 28
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center CAUSE CORRECTION PROBLEM 1. Out of fuel. Fill fuel tank. Will not start 2. See "TO START ENGINE" Engine not "CHOKED" properly. in Operation section. 3. Wait several minutes Engine flooded.
Page 29
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM CAUSE CORRECTION Loss of power 1. Cutting too much grass/too 1, Set in "Higher Cut" position/ fast. reduce speed, 2. Throttle in "CHOKE" 2. Adjust throttle control. position.
Page 30
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM CAUSE CORRECTION Mower blades will 1. Obstruction in clutch Remove obstruction. not rotate mechanism. Worn/damaged mower Replace mower drive belt. drive belt. Frozen idler pulley. Replace idler pulley.
Page 31
TRACTOR - - MODEL NUMBER 917.272453 SCHEMATIC BL&CK BATTERY p '_J FUSE AMMETER STARTER (OPT,ONAL) ..nE__9__o i ..CLUTCH / BRAKE (PEDAL SEAT SWITCH IGNITION _ _ _ 4 ..(NOT OCCUPIED) SWITCH 8t_CK (CLUTOH I ggOU g4 GROUNDING (OPTIONAL) B_CK IGNITION...
Page 32
TRACTOR - - MODEL NUMBER 917.272453 ELECTRICAL...
Page 44
TRACTOR -- MODEL NUMBER 917.272453 LIFT ASSEMBLY 25 24 ,,50 1.3 _ ("_" K...
Page 45
TRACTOR -- MODEL NUMBER 917.272453 LIFT ASSEMBLY PART DESCRIPTION 159460 Wire Asm Inner/Sprg W/plunger LT 159471 Shaft Asm Uft RH w/Inf 105767X Pin Groove 1 500 Zinc 12000002 E Ring#5133-62 19211621 Washer 21/32 X 1 X21 Ga 120183X Bearing Nylon BIk 629 Id 125631X Gdp Handle 122365X...
Page 46
TRACTOR -- MODEL NUMBER 917.272453 MOWER DECK _47 142 103 105 >21...
Page 47
TRACTOR - - MODEL NUMBER 917.272453 MOWER DECK KEY PART KEY PART DESCRIPTION DESCRIPTION Knob Custom Oval 165892 Mower Deck Assembly, 42" 149846 V-Belt Bolt 144959 ST0533107 138617 Bracket Assembly,Sway Bar, ST6541437 MulcherCover Front 136420 Screw Pan HD Phillip 10-24 x 5/8 165460 Bracket Sway Bar 38/42"...
Page 48
TRACTOR - - MODEL NUMBER 917.272453 PEERLESS TRANSAXLE-MODEL NUMBER 206-545C 7o . ,-,.--0 _UMBERS HERE...
Page 49
TRACTOR - - MODEL NUMBER 917.272453 PEERLESSTRANSAXLE-MODELNUMBER206-545C KEY PART KEY PART DESCRIPTION DESCRIPTION 772147 Transaxle Cover 786026 DowelPin 780086A Needle Bearing 5/8" 792076A FlatWasher 770128 Transaxle Case .312 ID x .059W 776395 Countershaft 790079 Brake Lever 776409 Output Shaft 792073A Screw 1/4 - 20 x 1-1/4"...
Page 50
TRACTOR - - MODEL NUMBER 917.272453 BRIGGS & STRATTON ENGINE-MODEL NUMBER 445777, TYPE NUMBER 0172-E1 929A| 10 _,_,_I 213_ 2678 21611 188 _ 1627 0...
Page 52
TRACTOR - - MODEL NUMBER 917.272453 BRIGGS& STRATTON ENGINE-MODEL NUMBER445777,TYPE NUMBER0172-E1 1005'-_ 3320 165_ 1095MD, L VE GASKET SET 868@ 334y 16a_ 1022_ 358 ENGINE GASKET 51 _ 276_ 943 (_...
Page 53
TRACTOR - - MODEL NUMBER 917.272453 BRIGGS & STRA'I-rON ENGINE-MODEL NUMBER 445777, TYPE NUMBER 0172-E1 KEY PART KEY PART DESCRIPTION DESCRIPTION Carburetor 499804 694001 Cylinder Assembly VaIve-Threttle 690993 499585 Kit-Bushing/Seal (Magneto Kit-Throttle Shaft 499805 Side) Float-Carburetor 499806 391086 • Seal-Oil (Magneto Side) 499803 Tube-Fuel Transfer...
Page 54
TRACTOR -- MODEL NUMBER 917.272453 BRIGGS & STRAI-rON ENGINE-MODEL NUMBER 445777, TYPE NUMBER 0172-E1 PART PART DESCRIPTION DESCRIPTION 499486 Filter-Air Cleaner Cartridge 499602 Assembly-Dipstick/Tube 691003 Screw (Air Guide Cover) 493880 TerminaI-Sparkplug 447A 690960 Screw (Air Guide Cover) 691011 Adapter-Air Cleaner 691008 Knob-Air Cleaner...
Page 55
SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION 1. Fold this page along dotted line Indicated above. 2. Hold page before you so that its left edge Is vertically parallel to a tree trunk or other upright structure, 3. Sight across the fold in the direction of hill slope you want to measure. 4.
Page 56
Your Home For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories owner's manuals that you need to do-it-yourself.
Need help?
Do you have a question about the 917.272453 and is the answer not in the manual?
Questions and answers