Craftsman 113.299720 Owner's Manual page 6

Installation Procedure (continued)
6. The next step is to install the eye bolts
in the top of the unit. To do this, you
must remove the three filters first.
Refer to drawing under "Maintenance"
section for location of three types of fil-
ters.
7. The Pre Filter (intake) slides out of the
channel in the cabinet.
8. The Fine Filter (mid bag type) has a
screw at the center of the bottom of
the cabinet. To remove the Fine Filter,
remove screw and slide filter out about
2" to the right. Push left end of filter
into cabinet about 4". Slide filter fur-
ther into cabinet at an angle. Tilt in at
top and pull filter towards you.
9. The diffuser (exhaust) slides out of the
channel in the cabinet.
10. Install a hex nut on an eye bolt until 1/4"
of thread is showing below the eye. Slip
on a Iockwasher and put eye bolt in hole
in top of cabinet. Repeat for other three
eye bolts.
1 1. Slip Iockwasher and hex nut on eye
bolt as shown on Figure "B". Repeat
for other three eye bolts and then
tighten nuts with two wrenches until all
nuts are snug.
12. Filters can be reinstalled at this point.
• Diffuser (exhaust) - slide into chan-
nel.
• Fine Filter (mid bag type) - reverse
motions for removing the fine filter,
shown in step 8. Reinstall bottom
screw.
• Pre Filter (intake) - slide into chan-
nel.
WARNING: Although compact in
size, the Air Filtration Unit weighs
40 Ibs. To avoid back injury obtain
to lift the unit into place.
Ceiling
Joist
Screw
Hook
Double
Loop
Chain
Lockwashem
Top
Cabinet
Eye Bolt
11" Height
of Unit