Operation; Maintenance - Craftsman 113.299720 Owner's Manual

Airborne filtration system
Table of Contents

Advertisement

Operation
WARNING:
To avoid fire or explo-
sion, do not operate
this filter
unit in
areas with flammable
gases
or flam-
mable vapors such as lighter fluid,
cleaners,
oil-base
paints, gasoline,
alcohol
or explosive
dust such as
coal, magnesium,
grain or gun pow-
der in the air. To avoid health haz-
ards from vapors or dusts, do not
use this system to filter toxic materi-
als. The Craftsman
Airborne
Filtra-
tion System
is intended
for indoor
use only. Unplug power cord before
changing
or cleaning
filters.
CAUTION:
The operation
of any
power tool can result in foreign
objects
being thrown into the eyes,
which can result in severe eye dam-
age. Always
wear safety goggles
complying
with CSA Z94-3-M88
(shown
on Package)
before com-
mencing
operation.
Safety Goggles
are available
at Sears hardware
stores.
Your Craftsman
Airborne
Filtration
Sys-
tem is equipped
with an Pull On/Pull Off
switch, a light to show power is ON, and a
power cord to plug into your electrical
out-
let.
When installation
is complete,
plug power
cord into wall receptacle.
To activate Air-
borne Filtration
System,
pull on switch
cord. Light will come on and filter unit is in
operation.
To stop operation,
pull on
switch cord and the light will turn off.
Remove
power cord from wall receptacle
before changing
or cleaning
filters.
WARNING:
To reduce the risk of fire
or electrical
shock, do not use this
Airborne
Filtration
System
with any
solid-state
speed control
device.
Maintenance
IMPORTANT:
To assure product safety
and reliability,
repairs and adjustments
should
only be performed
by Sears Ser-
vice Centers,
always using Sears replace-
ment parts.
Filter Maintenance
WARNING:
To avoid injury from
]
accidentally
starting,
unplug power
I
cord before cleaning
or changing
fil-
ters.
Cleaning
Your Airborne
Filtration
System consists
of three types of filters as shown under
"Removal"
#1 - Pre Filter (intake)
Polyurethane
foam
#2 - Fine Filter (mid-bag type)
Non-woven
polyester
#3 - Diffuser (exhaust)
Expanded
aluminum
The #1 Pre Filter and #3 Diffuser can be
washed
in warm water with a mild deter-
gent, dried and then reinstalled.
Check
the filters for tears or small holes. Do not
use a filter with holes or tears in it.
Replace it immediately.
To maintain
peak
performance
clean your filters often. Han-
dle the filters carefully, when removing
to
clean or when installing.
The #2 Fine Filter should
be replaced
when it becomes
clogged with fine dust. A
visual inspection
can be done by sliding
the #1 Pre Filter out and checking
the
Fine Filter for contents
and tears or holes.
If tears or holes appear,
replace your filter
immediately.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents