Fisher & Paykel E402B Installation Instructions And User Manual page 8

Installation instructions
12 Attach double sided foam to the back of the water filter head as shown
in Diagram 5. Write the date to be replaced on the filter (date installed +
6 months). Remove double sided foam backing and attach filter to the
desired position as located in step 11 (refer to previous page).
'13 Run the 6 mm (14") tubing to back of the fridge ensuring there is enough
tubing to pull out the refrigerator for service.
'14 Connect tubing into the water (solenoid) valve located on the right hand
side of the unit (compressor) compartment as shown in Diagram 7. Beware
of hot pipes.
'15 Pull gently on tubing to ensure it is locked in as shown in Diagram 8.
'16 The completed installation should look like Diagram 9 on page 7.
Diagram 5
Fig,8 Double sided
foam attachment
i!I
-'_-:_I"W _ Fig.P#_,terline connection
. i i± _ to refrigerator :
Diagram 6
17 Turn isolating tap on and check that all connections are dry and free of drips.
,'== coil water line t ubing behind the fridge. Push your refrigerator into place being careful not to
kink orsquash the water line running into thewater lsolenoidl valve.
,,=9 Turn o nrefrigerator.
:,oThe first t ime you require water outofthe dispenser, therewUl bea delay w hUe thewater
reservoir fills up. As this is happening, the @
symbol
will flash. Once the reservoir is fuji, this
symbol will stop flashing.
2"_ Run
a
further 3 [itres (3 qt)through the system to ensure the reservoir is flushed out. _:i
22You are now ready toenioy c hilled water and icedispensing from your A_t,Ve S_n'_' refrigerator. /