Fisher & Paykel E402B Installation Instructions And User Manual page 7

nsta ation instructions
Installation instructions:
1 Ensure that refrigerator is not plugged into a power supply.
2 Remove the compressor compartment cover from the rear
of the refrigerator (USA market only).
3 Locate isolation tap for water connection - cold water feed
only (dishwasher or sink mixer taps) - if you can't find the
connection tap, contact an authofised plumber in your state
or town to fit your water connection.
4 Connect the 200 mm (8") blue tubing to the outlet of the
PRV (blue coHet) and the inlet connection of the water filter
cartridge as shown in Diagram 1. Gently pull on both ends
to ensure it is locked.
5 Connect the white 6 mm (1/4")tubing to the outlet of the
water filter cartridge as shown in Diagram 2. Gently pull to
ensure it is locked.
6 Measure the required length of tubing to run from the PRV
to the water connection point.
7 Cut the tubing making sure the ends are square and clean.
s Connect the tubing to the tap connection and the base
of the PRV (white coJJet) and then to the tap as shown
Diagram 1
Fig,4 PRV connection
Diagram 2
Fig.5 Waterline connection
........................ in Diagram 3. Please note that the tap connection c_? .....
supplied shouH fit most installation situations. If .... _
your tap requires a different fitting, please contact an ........ "L_!
authorised plumber in your state or town to purchase
the correct fitting. _
9 Connect one locking key to each side of the water '_
fi[ter cartridge in between the cartridge and the II
locking colIet as shown inDiagram 4. I[
10 To flush the water filter and check for leaks, aim the \_
end of the tubing into a bucket, turn isolating tap on and :
run a t l east 3,tres (3 qt)of water through Once complete,
turn so at ng tap off _ _ T............ ii
11 Locate desired position for water filter noting carefully the [
following points= ii
o It is recommended to fit the filter in a vertical //,_ j/_.
orientation with the water filter head at the top. This will [
minimise water leakage when replacing cartridge.
Ensure the filter is in
a
convenient location to access _.[. {
every 6 months for replacement. We suggest that \_.._.-\<--_...
this location is beside the water filter supply tap in the /
cupboard beside the refrigerator, hf_,}_},,,,
o A minirnum clearance of 64 mm (2 W') from the _...,. _/9"/_
bottom of the filter cartridge is required to perform _. _(_/_
cartridge removal.
Diagram4 _ m.
Do not screw filter to frJdge. Fig.Z Locking key