Craftsman 917.28874 Operator's Manual page 10

,
ATTACH REAR LIFT LINKS (C) - Insert
rod end of link assembly into hole in tractor
lift shaft suspension arm (L) and pivot link
down to mower. Lift rear corner of mower
and position slot in link assembly over pin
on rear mower bracket (D) and secure
with washer and retainer spring.
9. Repeat on opposite side of tractor.
IMPORTANT: Check belt for proper routing
in all mower pulley grooves.
14. Install belt onto engine clutch pulley (M).
10.Turn steering wheel to position wheels
straight forward.
11 .ATTACH FRONT LINK (E) - Work from
left side of tractor. Insert rod end of link
assembly through front hole in tractor
front suspension bracket (F) and secure
with retainer spring (G) through hole in
link located behind the bracket.
12. Insert other end of link (E) into hole in
front mower bracket (H) and secure with
washer and retainer spring (J).
13. Disengage belt tension rod (K) from lock-
ing bracket (L).
15. Engage belt tension rod (K) on locking
bracket (L).
AOAUTION: Belt tension rod is spring load-
ed. Have a tight grip on rod and engage slowly.
16. Raise attachment lift to highest position.
17. If necessary, adjust gauge wheels before
operating mower as shown in the Opera-
tion section of this manual.
02937
10