Table of Contents
Advertisement
Available languages
Available languages
r_.._'.] :hV_ I:] Ib'dl
SIDE HANDLE
ATTACHMENT:
NOTE: Holes
in the unit are tapped
requiring
no nuts for installation.
• Attach the handle using four 14-10 x 5/8 hex screws.
Do not over tighten
the screws.
CASTER
INSTALLATION:
NOTE: Use adequate
manpower
for this operation.
• Remove
casterpack
from the bottom drawer.
Make sure all casters.
Screws,
and
nuts are accounted
for. (16) Screws
and nuts.
• Remove
the bottom drawer.
See operation
section:
Removing
and Installing
Drawers.
• Place the unit on its top. Use the packaging
material
to protect
the paint finish.
• Attach casters
using four 1/4-20 x 5/8 hex screws and nuts per caster.
Wrench
tighten all screws.
• Return the cart to its upright
position.
\
\
[e]'.,1:1 t ;:ll / [e_
REMOVING
AND INSTALLING
DRAWERS:
• Empty the drawer.
• Fully extend the drawer.
• Lever Style:
Lift or lower (depending
on the slide) the
release
lever on both sides (this allows the slides to ride
over the stops). Pull out to remove.
Tab Style:
Depress
the release
tab on both sides (this
allows the slides to ride over the stops). Pull out to
remove.
• To reinstall,
push the drawer
into the slides until the
drawer
stops.
Release
Left
Release
Right
• To remove
the slide
from the unit, first remove the drawer (follow the
procedure
above).
Lift and hold the spring retainer,
and push the slide
upward.
The slide may now be removed.
• To reinstall
the slide,
place the slide in the appropriate
position
in the
unit. Pull it toward the front of the unit until the spring retainer
snaps into
position
and secures
the slide.
\
\
\-3
Advertisement
Table of Contents
