Craftsman EZ3 917.256611 Owner's Manual page 21

SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place motion control lever in neutral (N) position.
Place attachment clutch in "DISENGAGED" position.
, Turn ignition key "OFF" and remove key,
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TO REMOVE MOWER (See Fig. 20)
Place attachment clutch in "DISENGAGED" position.
Turn height adjustment knob to lowest setting,
Lower mower to its lowest position_
= Remove retainer spring holding anti-swaybar to chas-
sis bracket and disengage anti-swaybar from bracket,
• Remove retainer springs from suspension arms at
deck and disengage arms from deck.
, Raise attachment lift to its highest position.
Remove two retainer spnngs from each front link and
remove links.
• Slide mower forward and remove belt from electric
Clutch pulley,
• Slide mower out from under right side of tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
TO INSTALL MOWER
Follow procedure described in "INSTALL MOWER AND
DRIVE BELT" in the Assembly section of this manual.
ADJUSTMENT
NUTS
SUSPENSION
ARMS
CHASSIS
E
LIFT
LINKS
FRONT
SUSPENSION
BRACKET_
FRONT MOWER_
BRACKET
LINKS
FRONT
SUSPENSION
BRACKET
RETAfNER
SPRING
ANTI-SWAY
BAR RETAINER
SPRINGS
BRACKET
FIG. 20
2!