Eureka 2500 Series Owner's Manual page 10

FIGURE 1
Some Eureka carpet shampooer/
extractor models do not feature an
attachment hose and selector
knob. These features are specified
only on selected models.
10
B. Emptying the Recovery Tank
NOTE: Turn off the power switch and unplug the carpet shampooer/extractor
to empty the recovery tank.
1) Press the recovery tank latch downward to release the tank from the carpet
shampooer/extractor unit as shown in Figure 1.
2) Slide the recovery tank out from the lower portion of the carpet shampooer/
extractor unit.
3) Lift off the recovery tank lid and empty contents into a suitable water drain.
4) Rinse out the recovery tank and tank lid thoroughly.
5) Remove and clean the filter by rinsing it with water after each use. Place the
same filter back in the recovery tank as shown in Figure 2.
6) Replace the recovery tank lid by aligning notches in lid over tank tabs.
7) Close lid securely.
8) Return the recovery tank to the carpet shampooer/extractor unit.
9) Push the recovery tank all the way into carpet shampooer/extractor until secure.
Be sure the ridge on the latch snaps securely in place.
10) Resume cleaning.
Recovery
Tank
Latch
Recovery Tank
Slide
Automatic Shut-Off
The automatic suction shut-off functions when the recovery tank is full of
liquid. This can be detected by a noticeable difference in the motor sound.
Immediately turn off the unit when this happens and empty the recovery tank.
FIGURE 2
Recovery Tank
Filter
Tank Lid
Lift