Craftsman 358.350260 Operator's Manual page 6

KNOW YOUR SAW
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERAT-
ING YOUR CHAIN SAW. Compare the illustrations with your unit to familiarize
yourself with the location of the various controls and adjustments. Save this
manual for future reference.
Bar Tool
(chain adjustment) Hand Guard----_r_ Front Handle
L_ _ t_ I/ Starter Rope
[2:3_/ O+STOP
[/JL..__,,_L,_ Switch
_#'_ Pr_ber
Bar Oil Fill Cap Starter Fuel Mix Fill Cap
Housing
Cylinder Cover
Throttle Chain
Lockout Direction
Rear of Travel
Handle
Adjusting
Screw
I
V
+ [RAFTS
/
i / Guide Bar
Throttle Choke Bar Clamp Chain Bar Clamp Nuts
Trigger Lever Catcher
ON/STOP SWITCH
The ON/STOP Switch is used to stop
the engine.
THROTTLE TRIGGER
The throttle trigger controls engine
speed.
THROTTLE LOCKOUT
The throttle lockout must be pressed
before you can squeeze the throttle
trigger. This feature prevents you from
accidentally squeezing the trigger.
CHOKE/FAST IDLE LEVER
The choke and fast idle are set by pull-
ing the choke!fast idle lever out fully for
cold or refueled starting. The choke
provides additional fuel to the engine
during cold starting.
PRIMER BULB
The Primer Bulb circulates fuel to the
carburetor to provide quicker starting.
CHAIN TENSION
It is normal for a new chain to stretch
during first 30 minutes of operation.
You should check your chain tension
frequently. See Chain Tension under
the Service and Adjustments section.
6