Using Your Humidifier - Emerson MoistAir HD14070 Owner's Manual

Operating the Controls
The SET readout has a range of 25% to
65% and is adjusted in increments of 5%.
Initially depressing the humidity button
will display the current humidity setting.
Each additional press of the button
increases the setting by 5%. A SET point
of 65% operates the humidifier
continuously regardless of the ROOM
reading. The humidistat that senses the
readings is located on the power cord.
Insure that this humidistat is free from
obstruction.
(continued)
Using Your Humidifier
Refill Display Function
For maximum run time both bottles
should be filled. When both bottles are
empty the display alternates the room
humidity reading and "F" (FILL),
informing additional water is required.
Mots/AIR
Refill Display
Manual Dry Out
At the end of the humidification season or
if you do not plan to run the humidifier for
one week or more, a manual dry out
mechanism is provided to completely dry
out the humidifier cabinet.
To do this, simply slide the float retainer
located at the back of the humidifier
cabinet to the top position of the slot it is
located in. This will hold the float in an
upward position and the fan will run until
you turn the power off.
NOTE: Be sure to position float retainer
to the normal operating mode (lowest
position in slot) for normal humidifier
operation.
Below is a diagram of the slot the float
retainer is located in, at the back of the
cabinet.
Back of Cabinet
Top Position
is for Manual
Dryout
Bottom Position
is for Normal
Operation Mode
Float
Retainer
Slot