Emerson MoistAir HD14070 Owner's Manual page 8

Operating the Controls
Where you set your desired humidity
levels depends on your personal comfort
level, outside temperature and inside
temperature. A starting set point of 30% -
40% ROOM humidity is recommended
but there may be conditions that require a
different setting.
IMPORTANT: Water damage may
result if condensation starts to form
on windows or walls. Humidity SET
point should be lowered until
condensation no longer forms. We
recommend room humidity levels do
not exceed 50%.
When Outdoor Recommended indoor
Temperature is: Relative Humidity is:
-10 ° F -24 ° C 20%
2 ° F -18 ° C 25%
10 ° F -12 ° C 30%
20 ° F* -6 ° C* 35%
* and above
To Operate the Controls
Digital Display
Press the power/speed button once to
turn the unit on* O • Initially there is a
slight delay while the electronics
calibrate. Two bars (- -) appear during
this time. Once calibration is complete a
ROOM humidity reading between
20% - 95% will be displayed. A flashing
20 display indicates that the room
humidity is less than 20%.
NOTE: The default settings at initial
startup are (Ultra Quiet) FI fan speed
and 65% SET humidity. After desired
settings are selected by the user, they
remain as long as the unit remains
plugged in and there is no power
interruption. If the unit is unplugged the
original default settings are employed.
• Humidifier fan should operate at initial start
up. If it does not, refer to, "Fan not operating
(digital display is illuminated)" in the "Trouble
Shooting" section on page 14.
Function Buttons
Speed Button @
This humidifier is equipped with a
3-speed fan control. Initially depressing
the speed button will display the current
speed setting. Each push of the speed
button advances the mode through the
settings of (HIGH) F3, (MEDIUM) F2, and
(Ultra Quiet) FI.
The selected setting is displayed on the
digital readout. The higher the setting, the
faster water is evaporated and released
into the air. FI (Ultra Quiet) is the
quietest setting and is provided for
conditions that do not require a rapid
evaporation rate.
Speed
Humidity Control O
This button allows you to adjust the
humidity to suit your needs. This humidifier
will automatically cycle on and off as
required to maintain the selected setting.
The readout displays both actual (ROOM)
and desired (SET) humidity percentage
(%) settings when humidity control button
is pressed. The ROOM readout has a
range of 20% to 95%. If the room humidity
level is equal to or less than 20% the
display will show a flashing 20.