Induction Cooktop Diepjay#Essages - Electrolux E30IC75FSS1 Use & Care Manual

Fig. 1 6
Fig.17
induction Cooktop Display Messages
LED MESSAGESOR UGNT INDICATORS DNSPLAYED
BY COOKING ZONECONTROLS (CONT'D)
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
POWER LEVEL SETTINGS - The Cooking Zones have four separate Power Level LEDs.
Once active, the Cooking Zones will provide 15 Power Levels to choose from. These include 7
(Fig. 12), _, 3, £f, 5, 5, "I, B, 9; including precise half-increment Cooking Zone Power Levels
of 2. (2.5), 3. (3.5), _. (4.5), 5. (5.5) and 5. (6.5; See Fig. 14). The highest setting of Por
"Power Boost" provides 125% power level for 10 minutes (See Fig. 13). Each key pad touch
(or just holding down the Power Level key pad) will scroll through all the available power
levels for any Cooking Zone quickly (See pages 14-17 for complete instructions).
RESIDUAL HEAT- Once any Cooking Zone has been used for cooking and turned OFE and
if the cooktop surface temperature on any of the Cooking Zones is still too HOT, H (See Fig.
15) will appear in the LED display for the affected Cooking Zone. The H will continue to
display if the temperature is still too HOT.
KEEP WARM - Use the WARM (or LOW) key pad to activate the Warm setting for any of the
Cooking Zones. The ON/OFF key pad for the desired Cooking Zone must be activated first,
then touch the WARM key pad located in the Cooktop Main Control area once to set. L
(LOW) should appear in the corresponding Cooking Zone LED (See Fig. 16 & page 16 for
complete information).
PAN DETECTION - All four Cooking Zones will provide a Pan Detection message. If a Cook-
ing Zone is turned ON and no pan is detected for the Cooking Zone, the pan has been moved
or if the pan is not centered correctly or if the pan is not made of magnetic material, F(See
Fig. 17) will appear in the affected Cooking Zone LED display.