Craftsman 113.177370 Owner's Manual page 10

Emptying the Drum
I ARNING: To avoid injury from acci- I
dental starting, unplug power cord
before emptying the drum.
1. The vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the oppo-
site side slightly to empty the drum.
2. Another option is to remove the power
assembly. Pull the flexible latches out-
ward on each side of the lid to release
from the drum.
3. While holding the latches out, lift the
power assembly up and away from the
drum.
4. Lay power assembly upside down on a
clean area while emptying drum.
5. Dump the drum contents into the proper
waste disposal container.
WARNING: To avoid back injury or
falls, do not lift a vac heavy with liq-
uid or debris. Scoop or drain enough
contents out to make the vac light
enough to lift comfortably.
Cord Wrap/Carry Handle
The wet/dry vac has a convenient cord
wrap area/carry handle designed on the
rear of the vac. Simply, wrap the power
cord around the handle and snap the con-
nector on the plug to a wrap of the cord
and the cord is wrapped for storage.
Moving the Vac
1. Should it become necessary to pick the
vac up to move it, DO NOT pick the vac
up by the lid handles unless dust drum
is empty. To avoid dropping the vac due
to latches releasing or possible part
breakage, pick the vac up by the lip of
the dust drum.
Blowing Feature
Your vac features "Full Blowing". It can
blow sawdust and other debris. Follow the
steps below to use your vac as a blower.
WARNING: Always wear safety gog- I
gles complying with ANSI Z87.1
I
before using as a blower.
WARNING: To avoid injury to I
bystanders, keep them clear of blow-
I
ing debris.
1. Locate blowing port of your vac.
2. Insert soft end of your hose into blowing
port.
3. (Optional) Attach extension wand to
swivel end of hose, then place a blower
nozzle on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.
Sears recommended accessories are
available at Sears retail stores. The Sears
Blower Nozzle Stock No. 9-16933 and
extension handles Stock No. 9-16964 are
recommended for blowing debris.
End
Swivel End
of Hose
Extension
Wand
)ptional)
Blowing Nozzle
(Optional)
10