Pressure Washer Rinsing; How To Use The Hose Reel; Automatic Cool Down System (Thermal Relief) - Craftsman 580.752700 Owner's Manual

Pressure Washer Rinsing
After detergent is applied, scour the surface and rinse
it clean as follows:
1. Apply safety latch to spray gun.
2. Make sure both chemical shut-off valves are in
"Off" position.
3. Remove black chemical spray tip from nozzle
extension.
4. Select and install desired high pressure spray tip,
as described in "How to Use Spray Tips".
5. Keep spray gun a safe distance from spray
surface.
WARNING
.
.
Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
Apply a high pressure spray to a small area and
then check the surface for damage, if no damage,
proceed to step 7.
Start at top of area to be rinsed, working down
with same overlapping strokes used for cleaning.
How to Use the Hose Reel
Your cleaning system is equipped with a hose reel
designed to store the hose when unit is not in use.
See "Prepare Unit for Storage" for long term storage of
more than 30 days.
After each use:
1. Disconnect hose from spray gun and high
pressure outlet on pump.
2. Drain water from hose.
3. Slide one end of hose into hole on hose reel. Turn
hose reel with handle to coil hose onto reel.
'\
IMPORTANT: DO NOT use your cleaning system with
the hose coiled onto the hose reel. The hose reel is for
storage purposes only.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125°F. The system engages to
cool the pump by discharging the warm water onto
the ground.
12