Trimmer; Tires; Trimmer Line; Engine Lubrication - Craftsman 917.773422 Owner's Manual

TRIMMER
Alwaysobsawe safety ruleswhen perform-
ing any maintenance.
TIRES
• Keeptiresfree of gasoline,oil, or insect
controlChemicals whichcan harm rubber.
• Avoidstumps,stones, deep ruts,shaq)
objectsand other hazardsthatmay cause
tiredamage.
TRIMMER MNE
For best results, replace trimmer Lines
when they have worn to half their original
length. Use .155 inch diameter trimmer
line. Cut new tdmmer line length to 18-3/4
inches. After new line is installed on
tdmmer head, check all lines so they do
not vary more then one (1) inch in length.
This is important to make sure the trimmer
head is balanced and will not v{brate
abnormally.
A.WARNING: Use only the specified
trimmer line. Do not use other materials
such as wire, string, rope, etc. Wire can
break off during trimming and become a
dangerous missile that can cause serious
injury.
TO REPLACE TRIMMER LINE
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Remove worn trimmer line from line
carrier plate.
3. Fold new, cut to length, trimmer line in
half and insert folded end through
carrier plate opening to back side of
retainer clip.
4. With folded end of line at back side of
retainer clip, pull line outward until
line is fully seated under the retainer
clip.
5. Repeat on other side of carrier plate.
6. Check all lines to be sure they are the
same length.
7. Reconnect spark plug wire to spark
plug.
Trimmer
line
Carrier plate
opening
cl_p
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification SF-SJ.
Select the oil's ShE viscosity grade
according to your expected operating
temperature.
NOTE: Although multiwiscosity oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi-viscosity oils
will result in increased oil consumption
when used above 32°F. Check your
engine oil level more frequently to avoid
possible engine damage from running
low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
unit is not used for 25 hours in one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil
level.
10