Howto Useaccessory Tray - Craftsman 580.752240 Operator's Manual

How to Stop Your Pressure Washer
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW position, then STOPposition (A).
3. ALWAYSpoint spray gun in a safe direction, push red
button and squeeze spray gun trigger to releaseretained
high water pressure.
iMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARHIHG
The high pressure stream of water that this
equipment produces can cut through skin and its
_ nderlying tissues, leading to serious injury and
_ossibleamputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
. ALWAYS pointspraygun in safedirection,pressred button
and squeeze spraygun trigger,to releasehigh pressure, e very
time youstop engine.
Howto UseAccessory Tray
The unit is equipped with an accessorytray with places to
store your spray gun, spray tip extension and quick connect
spray tips. There is also a hook at the front of the accessory
tray to hold your high pressure hose.
NOTE:The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo spray tip. The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1. Place spray tip extension through hole on accessory
tray, as shown.
2. Place spray gun through hole on accessory tray on right
side of unit.
3. Insert multi-colored spray tips in spaces provided in
accessory tray.
4. Hang high pressure hose on hook attached to accessory
tray on front of tray, as shown.
How to Use Spray Tips
The quick-connect on the spray tip extension allows you to
switch between three different quick connect spray tips.
Spray tips can be changed while pressure washer is running
once spray gun trigger lock is engaged.The spray tips vary
the spray pattern as shown below.
Low Pressure High Pressure
Black 25° Green 0° Red
Use to apply 1650 PSI 2200 PSI
detergent 2.2 GPM 1.9 GPM
Followthese instructionsto changespray tips:
1. Pull back collar on quick-connect and pull current spray
tip off. Store spray tips in holder provided on the
accessory tray.
WARHIHG
The high pressure stream of water that this
1_ lequipment produces can cut through skin and its
iunderlying tissues, leading to serious injury and
i possible amputation.
. NEVER exchange spraytips without lockingthe triggerlock on
thespraygun.
* DONOTtwist spraytips whilespraying.
2. Select desired spray tip:
* For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
* For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select green 25°
spray tip.
* To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
3. Pull back on collar, insert new spraytip and releasecollar.
Tug on spray tip to make sure it is securelyin place.
13