How To Stop Your Pressure Washer; Howto Useaccessory Tray - Craftsman 580.752590 Operator's Manual

_i, WARNING Contact with muffler area can result in
serious burns.
_ heat/gases can ignite
Exhaust
combustibles, structures or damage
fuel tank causing a fire.
* DO NOTtouch hot parts and AVOID hot exhaust gases.
* Allow equipment to cool before touching.
* Keepat least5 feet (152 cm) of clearanceon all sides of
pressure washer including overhead.
* It is a violation of California Public Resource Code,Section
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered landunless the exhaust
system is equipped with a spark arrestor, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may havesimilar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a spark arrestor designed for the exhaust system
installed on this engine.
* Replacement parts must be the sameand installed in the same
position as the original parts.
Howto Stop Your PressureWasher
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW position, then STOPposition.
_i, WARNING Backfire, fire or engine damagecould
occur.
• DONOTstop enginebymovingchokecontrolto "Choke"
position(1_1).
3. Rotate fuel shut-off valve to "Off" position.
4. ALWAYS point spray gun in a safe direction, push red
button and squeezespray gun trigger to releaseretained
high water pressure.
NOTICE Spray gun traps high water pressure, even when
engine is stopped and water is disconnected.
A, WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
* Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
* ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
Howto UseAccessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, spray tip extension and quick connect
spray tips. There is also a hook at the front of the accessory
tray to hold your high pressure hose.
NOTICE The extra hole in the tray is for storing a utility
brush. The extra clip in the tray is for storing a turbo spray
tip. The brush and turbo nozzle are NOT included with your
pressure washer. You can buy these items as optional
accessories.
1. Place spray tip extension through hole on accessory tray,
as shown.
2. Place spray gun through hole on accessory tray on right
side of unit.
3. insert multi-colored spray tips in spaces provided in
accessory tray.
4. Hang high pressure hose on hook attached to accessory
tray on front of tray as shown.
13