Craftsman NEXTEC 320.35078 Operator's Manual page 16

TO iNSTALL THE SANDPAPER
(Fig. 12a)
,_ WARNING: Check that the
sanding plate and sandpaper are
correctly attached. An incorrect or
insecurely fastened application tool
can come loose during operation
and cause a hazard.
1.
Follow the directions for
attaching the application tool
to attach the sanding plate to
the multi-tool.
Fig. 12a
Sandpaper
2. Align the sandpaper with the sanding plate and use your hand to press it
firmly onto the sanding plate.
3. Press the sandpaper firmly against a smooth surface for a short period of
time, then turn on the tool. The burr will form a non-slip bond with the outer
edge of the sandpaper felt. This will avoid premature wear.
4. If one point has become worn, pull off the sandpaper, turn it 120 ° and place
it on the sanding plate again.
SANDING (Fig. 13}
,_ WARNING: Do not touch the
motor housing after prolonged
use; it could be very hot.
= The removal rate and
the sanding pattern are
determined by the choice
of sanding sheet and the
work surface.
13
Apply uniform sanding
pressure to extend the life of
the sanding sheets.
• Intensifying the sanding pressure does not lead to an increase of the
sanding capacity; it increases wear on the machine and the sanding sheet.
For precise sanding of edges, corners and hard to reach areas, use only the
tip or an edge of the sanding sheet.
When selectively sanding on one spot, the sanding sheet can heat up
considerably. Remove the tool from the surface periodically to permit the
sanding sheet to cool down.
A sanding sheet that has been used for metal should not be used for
other materials.
• Use only Craftsman sanding accessories.
Page 16 35078 Manual_Revised_12 0615