Advertisement
ADDITIONAL
SAFETY
INSTRUCTIONS
FOR UNIVERSAL
JIG
1. Always feed the Jig all the way past the saw blade
or cutter.
2. Never pull the Jig and workpiece back past the blade
after making a cut. Always remove the Jig from the
table after going completely past the blade.
3. Always clamp the workpiece with both clamps if at
all possible.
4. Always tighten
the workplece
securely
with the
clamps.
5. Always feed the Jig and workpiece through the cut
slowly.
6. Never stand in line with the blade or cutter.
7. Always observe the safety instructions furnished by
the manufacturer of your table saw. If you do not have
those instructions, it is absolutely necessary to contact
the manufacturer
of your table saw and obtain a copy
of the proper instructions. You must read and under-
stand all instructions in their entirety before using the
Universal Jig, or operating the saw.
8. Always be sure that the Jig is correctly
resting on
the saw table top with the protruding part of the base
fully in the saw table miter slot before inserting and
clamping the workpiece,
or making a cut.
Failure to observe all safety rules could result in prop
erty damage and/or
serious personal injury.
9. WARNING.
THE TABLE
SAW GUARD
MUST
BE
REPLACED
IMMEDIATELY
AFTER COMPLETION
OF
THE
OPERATION,
IF THE
OPERATION
REQUIRED
REMOVAL
OF THE GUARD.
%" BOLTS
%" WASHERS
C-- CLAMP ASSEMBLIES
A
ANGLE PLATE
1/4" WING
NUTS
1/4" FLAT
K
KNOB
\
S
SCALE
G
1/4" BOLTS
LOCATING
GUIDES
FIG. 1
B
BASE PLATE
COMPONENTS
OF THE UNIVERSAL JIG ARE LISTED BELOW (REFER TO FIG. 1 FOR IDENTIFICATION).
Key
Description
Qty.
Key
Description
Qty.
A
Angle Plate
1
V4" Flat washers
4
B
Base Plate
1
%" Bolts for Clamp assemblies
2
C
Clamp Assemblies
2
%" Washers to go under bolts
2
G
Locating Guides
2
K
Knob for Clamping Base to angle plate
1
!4" bolts for locating guides
4
S
Scale on base plate
1
!/4" wing r_uts FIV4" bolts
4
Advertisement
