Craftsman 944.359220 Owner's Manual page 7

TO ASSEMBLE GRASS CATCHER
1. Putgrass catcherframe intograss bagwith
rigid part of bag on the bottom. Make sure
the frame handle is outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Frame
Vinyl Frame
bindings opening
TO PREPARE BATTERY
NOTE: Your battery must be charged be-
fore you can start your lawn mower. Avoid
charging battery in extremely hot or cold
temperatures.
1. Open motor shroud. Remove and
discard battery insulator tag between
battery and motor connector.
NOTE: The battery can be charged while
in or out of the lawn mower.
2. Plug battery charger into 110 volt A.C.
outlet. Plug other end of charger into
the port on the battery.
3. Leave battery charger connected for
24 hours before starting your engine
for the first time. The green LED on
the charger will light when the battery
is fully charged.
IMPORTANT: Do not store charger inside
of motor or on top of battery.
_I, WARNING" Do not attempt to operate
mower while battery is charging.
_I, CAUTION: Only use battery charger
approved by the manufacturer of your
mower. Using a charger not approved by
the manufacturer of your mower is hazard-
ous, could damage your mower and void
your warranty.
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bag-
ging or discharging, see "TO CONVERT
MOWER" in the Operation section of this
manual.
Battery
insulator
tag
Battery
charger
Battery
LIGHT MODE
Solid RED
Solid GREEN
BATTERY CHARGER LED INDICATOR
BATTERY STATUS
Charging
Battery is fully charged
orcharger is plugged in
without battery attached
7