Download Print this page

Craftsman 358.794771 Operator's Manual page 11

25cc/1.5 cu.in. 2-cycle 215 mph/470 cfm gasoline powered blower/vac

Advertisement

Available languages

Available languages

Starter
_;_.
/"
Handl_
4. This unit has the Sim-pul
" starting
system. You do not have to pull the
starter rope handle sharply or
briskly. Pull starter rope handle 5
times with a controlled
and steady
motion (no more than 3 times
above 90°F). If engine starts and
runs prior to 5 pulls, allow engine to
run for 5 seconds;
then, fully
squeeze the throttle trigger to dis-
engage the starting system
(start
lever returns to RUN position).
Steps 5 and 6 are not necessary.
5.
Fully squeeze the throttle trigger to
disengage the starting system (start
lever returns to RUN position).
6. Pull starter rope handle with a con-
trolled and steady motion while
squeezing
throttle trigger until
engine starts and runs.
STARTING
A WARM ENGINE
1. Squeeze and hold the throttle trigger.
2. Pull starter rope handle with a con-
trolled and steady motion while
squeezing
throttle trigger until en-
gine starts and runs.
NOTE: Normally, the warm starting
procedure
can be used within 5-10
minutes after the unit is turned off. If
the unit sits for more than 10 minutes
without
being used, it will be necessary
to start the unit by following
the steps
under STARTING A COLD ENGINE or fol-
lowing the starting instruction
steps
shown on the unit.
STARTING
A FLOODED
ENGINE
Flooded engines can be started by mov-
ing the start lever to the RUN position
and fully squeezing
the throttle trigger.
Pull the starter handle repeatedly
while
squeezing
throttle trigger until engine
starts and runs. This could require pull-
ing the starter handle many times, de-
pending on how badly the unit is
flooded.
If the unit still doesn't start, re-
fer to the TROUBLESHOOTING TABLE or
call 1-800-235-5878.
CUSTOMER
RESPONSIBILITIES
_,
WARNING:
Disconnect
the spark plug before performing
maintenance,
service, or adjustments.
CARE & MAINTENANCE
TASK
Check for loose fasteners and parts
Check for damaged
or worn parts
Inspect and clean unit and labels
Clean air filter
Replace spark plug
Replace fuel filter
Check muffler mounting
screws
_WARNING:
Avoid touching
muf-
fler unless engine and muffler are cold.
A hot muffler can cause serious burns.
_WARNING:
Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum
in-
let door or attempting
to insert or re-
move the vacuum
or blower tubes.
The rotating blades can cause serious
injury. Always disconnect
the spark
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Yearly
Yearly
Yearly
plug before performing
maintenance
or
accessing
movable
parts.
GEN ERAL RECOMMEN
DATIONS
The warranty
on this unit does not cov-
er items that have been subjected
to
operator abuse or negligence.
To re-
ceive full value from the warranty, the
operator must maintain
unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically
to
properly maintain
your unit.
-11
-

Advertisement

loading