Craftsman 917.28634 Operator's Manual page 26

Weak or Dead Fully Charged
Battery Battery
REPLACING BATTERY
WARNING: Do
not short battery
terminals by a!-
lowing a wrench
or any other object to contact
both terminals at the same
time. Before connecting bat-
tery, remove metal bracelets,
wristwatch bands, rings, etc.
Positive terminal must be con-
nected first to prevent sparking
from accidental grounding.
n ...........
Lift seat pan to raised position and
open battery box door°
Disconnect BLACK battery cable
first then RED battery cable and
carefully remove battery from trac-
tor,
Install new battery with terminals in
same position as old battery,
First connect RED battery cable to
positive (+) terminal with hex bolt
and keps nut as shown, Tighten
securely,
Connect BLACK grounding cable
to negative (-) terminal with remain-
ing hex bolt and
keps nut, Tighten
securely,
Close battery box door.
SEAT PAN
Terminal
_,eps
_,over / Nut
/ / Hex
Positiv
t:_
(Red)
Cable Negative
(Black) Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2, Remove bulb holder from the hole in
the backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in
the backside of the grill,
4, Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
, Check wiring, See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash,
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector,
3, Stand in front of tractor, Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4, When replacing hood, be sure to re-
connect the headlight wire connector,
Hood
Headlight Wire
Connector
BATTERY
BOX DOOR
26