Removal steps of I/O board
Step
Screw (quantity)
1
M2 × 4 mm, wafer-head, nylon-coated (1)
When installing: Make sure that the connector is attached firmly.
1130 System board, fan assembly, and backup battery
Important notices for handling the system board:
When handling the system board, bear the following in mind.
• The system board has an accelerometer, which can be broken by applying several thousands of G-forces.
Note: Dropping a system board from a height of as little as 6 inches so that it falls flat on a hard bench can subject
the accelerometer to as much as 6,000 G's of shock.
• Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or composite.
• If a system board is dropped, you must test it, using PC-Doctor for DOS if the system supports PC-Doctor for DOS,
to make sure that the HDD Active Protection still functions (see below).
Note: If the test shows that HDD Active Protection is not functioning, be sure to document the drop in any reject
report, and replace the system board.
• Avoid rough handling of any kind.
• At every point in the process, be sure not to drop or stack the system board.
74
Hardware Maintenance Manual
2
1
Color
Silver
3
Torque
0.181 Nm
(1.85 kgfcm)