HP Dv6 1360us - Pavilion Entertainment - Core 2 Duo 2.13 GHz Maintenance And Service Manual page 77

Removal and replacement procedures
Remove the system board:
1. Disconnect the following cables from the system board:
1 Modem module cable
2 Audio/infrared board cable
✎
The audio/infrared board cable connects to a LIF connector on the system board.
3 USB board cable
✎
The USB board cable connects to a LIF connector on the system board.
4 Power connector cable
2. Remove the Phillips PM2.5×7.0 screw 1 that secures the system board to the base enclosure.
3. Lift up on the right side 2 of the system board until it rests at approximately a 45-degree angle.
4. Lift the system board to the right and up and out of the base enclosure 3.
Reverse this procedure to install the system board.
4–38 Maintenance and Service Guide