Replacing The Hard Disk Drive Or Solid State Drive - Lenovo ThinkPad Edge E320 User Manual

4. Insert a fully charged battery until it clicks into place
battery latch to the locked position
5. Turn the computer over again. Connect the ac power adapter and cables to the computer; then turn it on.

Replacing the hard disk drive or solid state drive

Before you start, print these instructions.
You can replace the hard disk drive or solid state drive with a new one which can be purchased from your
Lenovo reseller or a marketing representative. To replace the hard disk drive or solid state drive, read the
following prerequisites, and select your model from the list below for instruction.
Note: Replace the hard disk drive or solid state drive only if you upgrade it or have it repaired. The connectors
and slot of the hard disk drive or solid state drive were not designed for frequent changes, or drive swapping.
Prerequisites for the procedure
When replacing the drive, be sure to follow the precautions.
Attention: When you are handling a hard disk drive or solid state drive:
• Do not drop the drive or subject it to physical shocks. Put the drive on a material, such as soft cloth, that
absorbs any physical shocks.
• Do not apply pressure to the cover of the drive.
• Do not touch the connector.
The drive is very sensitive. Incorrect handling can cause damage and permanent loss of data.
Before removing the hard disk drive or solid state drive, make a backup copy of all the information on it,
and then turn the computer off.
Never remove the drive while the system is operating, in sleep (standby) mode, or in hibernation mode.
Replacement instructions
To replace the hard disk drive or solid state drive, do the following:
1. Turn off the computer; then disconnect the ac power adapter and all cables from the computer.
2. Close the computer display, and turn the computer over.
1 as shown in the drawing, and then slide the right
2 .
.
Chapter 6 Replacing devices
69