Configuring Emulex Fcas With The Lpfc Driver - HP XP20000/XP24000 Configuration Manual

Hp storageworks xp disk array configuration guide: solaris (a5951-96305, september 2010)

Hide thumbs Also See for XP20000/XP24000:

Manual (448 pages)

Reference manual (372 pages)

Configuration manual (183 pages)

Table Of Contents

Table of Contents

NOTE:

There must be exactly 6 spaces between HP and OPEN.

Instead of using the default round-robin algorithm, add the following lines in addition to the previous

lines for systems with a large amount of sequential I/O activity:

device-type-mpxio-options-list=

"device-type=HP

logical-block-options="load-balance=logical-block", "region-size=18";

NOTE:

There must be exactly 6 spaces between HP and OPEN.

For further information see document IDs 76504 and 76505 at

For Solaris 8/9, perform a reconfiguration reboot of the host to implement changes to the config-

uration file. For Solaris 10, use the stmsboot command which will perform the modifications

and then initiate a reboot.

For Solaris 8/9, after you have rebooted and the LDEV has been defined as a LUN to the host,

use the cfgadm command to configure the controller instances for SAN connectivity. The controller

instance (c#) may differ between systems. Replace the WWPN in the example below with the

WWPNs for your array ports.

Example

# cfgadm -al

Ap_Id

Type Receptacle Occupant Condition

c3 fc-fabric connected configured unknown

c3::50060e8003285301 disk connected configured unknown

c4 fc-fabric connected configured unknown

c4::50060e8003285311 disk connected configured unknown

# cfgadm -c configure c3::50060e8003285301

# cfgadm -c configure c4::50060e8003285311