Dell EqualLogic PS4100 Hardware Manual page 44

Equallogic ps series iscsi storage arrays with microsoft windows server failover clusters
Hide thumbs Also See for EqualLogic PS4100:
Table of Contents

Advertisement

Problem
You are prompted to configure one
network instead of two during MSCS
installation.
Using Microsoft Windows NT 4.0 to
remotely administer a Windows
Server 2003 cluster generates error
messages.
Unable to add a node to the cluster.
44
Probable Cause
The system has just been
booted and services are still
starting.
The cluster network name is not
responding on the network because
the Internet Connection Firewall is
enabled on one or more nodes.
The TCP/IP configuration is incorrect. The node-to-node network and public
The private (point-to-point) network is
disconnected.
This is a known issue. Some
resources in Windows Server 2003
are not supported in Windows NT 4.0.
The new node cannot access the
shared disks. The shared disks are
enumerated by the operating system
differently on the cluster nodes.
Corrective Action
Use the Event Viewer and
look for the following events
logged by the Cluster Service:
Microsoft Cluster
Service
successfully formed
a cluster on this
node.
Or
Microsoft Cluster
Service
successfully joined
the cluster.
If these events do not appear
in Event Viewer, see the
Microsoft Cluster Service
Administrator's Guide for
instructions on setting up the
cluster on your system and
starting the Cluster Service.
Configure the Internet Connection
Firewall to allow communications that
are required by MSCS and the
clustered applications or services. For
more information, see the article
KB883398 at support.microsoft.com.
network must be assigned static IP
addresses on different subnets.
Ensure that all systems are powered
on so that the NICs in the private
network are available.
It is strongly recommended that you
use Windows XP Professional or
Windows Server 2003 for remote
administration of a cluster running
Windows Server 2003.
Using Windows Disk Administration
ensure that the new cluster node can
enumerate the cluster disks. If the
disks do not appear in Disk
Administration:
1. Check all cable connections.
2. Check the volumes assignments.
3. Select Advanced → Minimum.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents